IMAGES ARE FOR ILLUSTRATION ONLY… Although very similar, they are not an exact replica of the listing below.

Chassis & frame:

• Fully engineered crane ready steel chassis on skids: 6m x 3.2m.
• Hardwood internal floor, varnished with non-toxic hard wearing varnish or equivalent.
• Cypress pine frame (non-toxic, naturally termite resistant). 2.4m internal height at lowest point of ceiling, 2.7m at highest point.
• Wind rating N3 = cyclone rods, ply braced frame, strapping, tie down. Higher ratings can be achieved if required.
• Earthwool insulation; R1.5 batts in walls+ insulating building paper wrap; R1.8 batts in ceiling.
• Single sloping (skillion) roof at approximately 5 degrees.

External cladding, roof & internal finish:

• External cladding – Colorbond corrugated steel (choice of standard colours) with ‘J mould’ trim; varnished weatherboard above and below windows/doors; recycled timber stops running vertically.
• Trimdeck steel roof and steel fascia – choice of standard colorbond colours.
• Internal painted plasterboard sheeting (OR vertical VJ sheeting), Colonial style architrave, skirting & trim.

Windows & doors:

• 3 Aluminium sliding windows with fly screens.
• Aluminium sliding entry door with fly screen sliding door.
• Internal hollow core door; cavity wall sliding door for bathroom.

Kitchen:

• Kitchen cabinets with handmade, rustic, cupboard door and drawer faces. (Options available, or can be swapped for modern cabinetry.)
• Handmade hardwood benchtops from recycled timbers. (Can be swapped for alternates.)
• Stainless steel single sink & mixer tap.
• Tiled splash back (options available).
• space for bar fridge.

Bathroom:

• Tiled on floor, skirting, shower walls (approx. 2m high) and vanity splash back, painted elsewhere (tile & paint options).
• Acrylic shower base.
• Shower head on rail, mixer tap.
• Glass shower screen and door.
• Modern vanity sink & mixer tap; cabinet mirror; flushing toilet; toilet roll holder; towel rail.
• Flushing toilet.

Electrics, gas & water:

• Electrics – full wiring for 4 down-lights, 5 internal double power points, 1 external power point (for Hot Water System), 2 external lights, smoke alarm, switchboard all ready to be hardwired at install.
• Gas hot water system (bottle or mains fed) – ready to be connected at install.
• Water and waste plumbing to underside of floor – ready to be connected at install.

General:

• Certification for frame, chassis, electrics, plumbing for water and gas, waterproofing and energy efficiency assessment. (Typically all required for council approval / certification.)
• Non toxic and low-VOC materials used wherever possible.